Trabant
I started modeling a car. I picked the humble little Trabant.
I have not completed a car yet but I’m pretty pleased with this geometry so we’ll see where it goes.
I’m back on this car. I have the front end almost sorted out. Now I need to fix the A pillars and doors.
I am working on The Weekly Hard Surface Challenge on Polycount Forum. Here’s what I did this weekend. Modeled with Blender, rendered with Cycles.
Week 01 Part 01 - Screw
Wires:
Week 01 Part 02 - Bearing Block
Wires:
Week 02 - Air Motor
Wires:
Week 03 - Flange Bearing
Wires:
Dang, man! Loving everything about these. The renders are nice and clean and well presented with the black backdrop. Adding in the wires in the link is a cool addition. Clean looking topology as well! Keep it going.
Thanks for looking and commenting. I’m putting a lot of thought into creating good topology. And creating good looking materials with Cycles.
